LUX SNL180, superjasny neonowy elastyczny pasek LED, 1400 mm

The LUX SNL180 LED light strip has a length of 1400 mm.

The LUX SNL180 strip provides uniform LED lighting without visible hotspots, thanks to an advanced diffusion layer. It features full-spectrum CRGBW lighting.

This LED strip provides CRGBW lighting, which includes cold white, red, green, blue, and warm white.

Yes, the color temperature of the white light is adjustable from 2700K (warm white) to 6500K (cool white), allowing precise customization of the lighting ambiance.

The LUX SNL180 strip benefits from IP67 certification. This means it is suitable for installation both indoors and outdoors, including in damp areas, but it is not designed for permanent immersion in water.

Yes, it is made from UV-resistant materials and has passed salt spray tests, ensuring durability for marine applications.

The LUX SNL180 strip integrates 180 LEDs per meter, providing dense and bright illumination.

The LUX SNL180 strip has a nominal power of 5 watts per meter. For a length of 1400 mm (1.4 meters), the total power consumption is approximately 7 watts.

No, the LUX SNL180 L-band cable is supplied in ready-to-use lengths and is factory-sealed to meet IP67 standards. It must not be cut.

The minimum bending radius allowed for the LUX SNL180 cable is 120 mm. It must be bent only along the lateral axis and must not be bent along the vertical axis or twisted.

Always unroll the neon strip carefully along its entire length. Do not drop it or allow it to twist during installation. Do not apply excessive pressure, as this could damage the internal LED strip. Do not pull, stretch, twist, or bend the strip on its vertical axis. For lengths over one meter, it is recommended to use two people for installation.

Its "bend-flex" design allows it to be adapted to curved surfaces, such as under the gunwales, T-tops, or cabin ceilings. It should only be bent along the lateral axis.

The strip is installed using the supplied stainless steel clips. These clips are screwed into place, then the neon strip is simply pushed into the clips until an audible "click" confirms it is securely fastened. It is recommended to use multiple clips around tight curves.

Yes, before any installation, always ensure the vessel's power source and battery are disconnected or isolated. It is also recommended that a qualified professional performs the electrical and mechanical installation.

Although the neon strip is made from UV-resistant materials, it must not be installed in areas exposed to direct strong sunlight.

Yes, the LUX SNL180 LED strip is designed to be used exclusively with Lumishore LUX Neon Flex LED strip driver modules.

No, it is imperative not to connect the LUX SNL180 L-band to lighting control products or third-party drivers. It must be used exclusively with Lumishore LUX LED strip driver modules.

The required input voltage range is 23 to 25V. It must only be used with Lumishore LED strip driver modules.

The warranty may be void in case of misuse, abuse, incorrect installation, negligence, damage caused by disasters, installation by unqualified personnel, unauthorized repair or modification, or non-approved installations. Failure to comply with installation, maintenance, and usage guidelines also voids the warranty.

Yes, using the LUX Neon Flex light strip with third-party drivers will void the warranty. It is designed to operate only with the Lumishore LUX light strip driver module.