LUX SNL180, elastyczna taśma neonowa Superbright, 3000 mm

The LUX SNL180 LED light strip has a length of 3000 mm (3 meters).

The LUX SNL180 LED light strip provides a full spectrum of colors (CRGBW: cool white, red, green, blue, warm white) with adjustable white temperature from 2700K to 6500K.

Yes, the LUX SNL180 LED light strip is dimmable as standard, allowing you to adjust the light intensity to your preferences.

The LUX SNL180 LED light strip is rated IP67, meaning it is fully sealed and can be installed indoors or outdoors, including in damp areas. However, it is not designed for continuous immersion in water.

Yes, the LUX SNL180 LED light strip is made from UV-resistant material and has been tested for salt spray resistance, ensuring increased durability in a marine environment.

The LUX SNL180 LED light strip is equipped with 180 LEDs per meter, providing uniform and spot-free illumination.

The LUX SNL180 LED strip consumes 5 watts per meter. For a 3000 mm (3 meter) strip, the total consumption is 15 watts.

No, the LUX SNL180 LED light strip is supplied in pre-cut, factory-sealed lengths to meet IP67 standards. It must not be cut under any circumstances.

The LED strip is installed using stainless steel screw clips provided. Once the clips are fixed, the strip is pushed into place until a "click" confirms it is securely locked. It is recommended to use multiple clips around tight curves to ensure proper conformity.

Always unroll the LED strip carefully along its entire length; do not lift it by one end only. Do not let the strip fall or twist during installation. Do not apply excessive pressure, as this could damage the internal LED strip. Do not pull, stretch, twist, or bend the strip vertically. For lengths over one meter, it is recommended to work with two people.

The LUX SNL180 LED light strip has a minimum bend radius of 120 mm. It must only be bent along the lateral axis (side) and not along the vertical axis or twisted.

The LUX SNL180 LED light strip is suitable for indoor and outdoor installation, provided it is above the waterline. It is ideal for toe rails, cabin linings, or T-tops. Avoid areas exposed to direct sunlight.

Yes, it is imperative to always ensure that the boat's power source and battery are disconnected or isolated before proceeding with the installation.

Yes, a qualified professional should perform the electrical and mechanical installation of the LUX SNL180 LED strip.

The LUX SNL180 LED strip light requires the Lumishore LUX LED strip driver module to operate. It must not be connected to any other third-party lighting products or drivers.

The LUX SNL180 LED strip control is simple and intuitive. It can be operated either via a momentary switch or by integrating it with your compatible multifunction display (MFD) or a Lumishore screen.

The LUX SNL180 LED strip requires an input voltage range of 23 to 25V. It must be used ONLY with Lumishore LED strip driver modules.

LUMISHORE Ltd guarantees its lighting systems, including lights and associated accessories, against manufacturing defects for a period of three years from the original purchase date.

The warranty will be void in case of misuse, abuse, incorrect installation, negligence, improper shipping, damage caused by disasters (fire, flood, storm, lightning), installation by unqualified personnel, unauthorized repair or modification, or non-approved installations. Use with third-party autopilots not from Lumishore will also void the warranty.

If your lighting system encounters an issue during the warranty period, contact your dealer, the boat manufacturer, or your broker as soon as you detect the defect.