Prowadnica pozioma podwójna do kabli o średnicy 5 i 6 mm - kompozyt szary

The Scanstrut DS-HD6 cable gland is designed to provide professional watertight sealing when routing two cables through a deck or bulkhead on a boat. It protects the cables and the boat's interior from water and marine elements.

The Scanstrut DS-HD6 deck gland is made of gray composite, a material chosen for its robustness and resistance to marine environments.

Yes, the Scanstrut DS-HD6 deck pass-through is designed to withstand UV exposure and harsh marine environments, ensuring reliable durability and performance at sea.

The Scanstrut DS-HD6 deck plug is gray.

This bridge cable is a dual model, meaning it can accommodate two cables simultaneously.

Yes, the kit includes a total of six plugs: two blank plugs, two 5 mm plugs, and two 6 mm plugs, allowing flexibility for cable routing.

The Scanstrut DS-HD6 deck gland is specifically designed for cable diameters of 5 mm and 6 mm.

Yes, it is possible to run a single cable. The kit includes blanking plugs that can be used to seal the unused opening, or if you are only using one of the two passages.

The through-hull fitting is compatible with various deck and bulkhead materials, including soft materials like plywood, hard materials like fiberglass, hardwoods and acrylic, as well as metal surfaces such as steel and aluminum. Mounting methods vary depending on the material.

For installation, you will need the following tools:

A Pozidriv screwdriverA drillA hole saw or a 25 mm (1 inch) drill bitA 2.5 mm (3/32”) or 3 mm (1/8”) drill bit depending on the materialSilicone (not included)

You must select the plug whose diameter is closest to that of your cable. The kit includes 5 mm and 6 mm plugs, as well as blank plugs for precise adaptation.

The kit includes four self-tapping screws no. 6 x 16, as well as one M5x10 bolt (black).

For soft materials like plywood, drill pilot holes of Ø2.5 mm (3/32”) and use the supplied #6 self-tapping screws.

For hard materials such as fiberglass, hardwoods, or acrylic, drill pilot holes of Ø3 mm (1/8”) and use the supplied #6 self-tapping screws.

For metal surfaces such as steel or aluminum, drill pilot holes of Ø3 mm (1/8”). It is recommended to use a countersunk M3 bolt over 12 mm long with a washer and a Nyloc nut (not included).

Yes, a cutting template is included in the installation instructions to help you precisely mark the 25 mm hole location and mounting points.

Yes, it is important to deburr the drilled hole to ensure a smooth and clean surface before installing the deck gland, which contributes to better watertightness.