Convertor sinusoidal Mastervolt Mass Sine Ultra 24/4000

It delivers a continuous power output of 4000 W, even at an ambient temperature up to 40 °C, with no loss of efficiency.

Peak power reaches 7000 W. This energy reserve is ideal for starting complex, high-power equipment smoothly, such as air conditioning compressors or large electric motors.

It generates a pure sine wave alternating current (True Sine Wave) of 230 V with a total harmonic distortion (THD) below 1%. This ensures perfectly stable and safe power supply for your most sensitive electronic equipment.

The device has the following physical characteristics:

Height: 472 mmWidth: 318 mmDepth: 178 mmWeight: 15 kg

It is designed to operate with a 24 V DC battery bank. Its input voltage range is programmable and extends from 19 V to 32 V to accommodate different battery types.

Yes, thanks to its modular architecture and dedicated Sync ports, you can parallel-connect up to 10 units to multiply the overall output power of your electrical system.

Yes, the Mass Sine Ultra allows for complex three-phase configuration. You can integrate up to 9 units (3x3 configuration) to meet the needs of large-scale marine installations.

For optimal operation, it is recommended to use a battery bank with a capacity greater than 350 Ah.

To ensure system safety and efficiency, use DC cables with a minimum cross-section of 70 mm², always paired with an inline 250 A fuse.

No, its standby consumption is very well controlled to preserve your batteries:

16 W in normal operation7 W in energy-saving mode4 W in remote shutdown mode

Yes, it is fully compatible. It includes two MasterBus ports, enabling monitoring, configuration, and precise control of your installation via a MasterView display or a PC running the MasterAdjust software.

It has an IP23 protection rating. This means it is protected against contact with fingers and water spray at angles less than 60 degrees from the vertical. It is designed exclusively for indoor installation.

It operates optimally between -25 °C and 60 °C. Note that a preventive power reduction (derating) is automatically applied when the ambient temperature exceeds 40 °C to protect internal components.

The Mass Sine Ultra 24/4000 meets the strictest marine and mobile sector safety standards. It holds international certifications CE, ABYC, and E-mark.

Yes, it is essential to leave at least 150 mm of free space under the converter. This allows for easier cable routing, access to the DIP switches, and adequate ventilation to prevent hot air buildup.

Yes, the output frequency is selectable between 50 Hz and 60 Hz (±0.005%). This setting can be adjusted easily via the MasterBus network.

Yes, the front panel is equipped with a practical display panel including:

LED indicators showing power draw (in 20% increments)Battery charge statusAC output indicatorMain power On/Off switch

The device includes full automatic protections. It is protected against short circuits, overloads (indicated by a red LED on the front panel) and excessive internal temperatures. In case of a critical fault, the inverter goes into safety mode to prevent any damage.

The Mass Sine Ultra 24/4000 offers excellent energy efficiency with a maximum efficiency greater than or equal to 92%. This helps preserve the autonomy of your battery bank and minimizes energy losses in the form of heat.

Yes, for a secure installation fully compliant with local electrical regulations, it is essential to connect the neutral conductor (N) of the AC output to the ground (PE / GND) of your vessel or vehicle.