Indicator Digital i50 Tridata

The i50 Tridata display combines three essential data types: depth (with shallow-water alarms), speed (current, maximum, average, log, and daily distance), and water temperature. It also includes a race start chronometer for regatta crews.

Yes, the i50 series uses a segmented LCD display with high contrast. This technical choice, combined with large-sized digits and red backlighting, ensures maximum readability both day and night, even in high-brightness conditions.

Absolutely. The i50 Tridata has been specifically designed to provide a direct and easy replacement for the older ST60 generation. It maintains a similar footprint to fit perfectly into your existing dashboard cutouts.

Yes, the display is equipped with SeaTalk NG connectivity, which is Raymarine's standard compatible with the NMEA 2000 network. It thus integrates easily into modern navigation systems.

Yes, the i50 Tridata retains native backward compatibility with older SeaTalk 1 networks. This makes upgrading your instruments much easier without having to rewire your entire boat.

The device operates on a 12 V DC power supply (with a tolerance range from 10 to 16 V DC). It can be powered directly via the SeaTalk NG network.

No, one of the major advantages of its segmented LCD screen is its very low power consumption. The display alone typically consumes less than 1 W, which preserves the batteries of your sailboat or powerboat.

Yes, the display has an IPX6 waterproof certification. It is designed to withstand spray and breaking waves, making it perfectly suited for outdoor installation in your boat's cockpit.

You can configure the units according to your preferences during calibration:

Speed: Knots (KTS), miles per hour (MPH) or kilometers per hour (KPH). Distance: Nautical miles, statute miles or kilometers. Temperature: Degrees Celsius (°C) or Fahrenheit (°F).

To set the shallow depth alarm, navigate to the depth page, then press and hold the Trip and Reset buttons simultaneously to enter setup mode. You can then set the desired alarm threshold to navigate safely.

The i50 Tridata is compatible with a wide range of analog depth, speed, and temperature transducers. This includes through-hull models such as the P120, B45, P319, as well as transducers designed for internal hull mounting (P79) or transom mounting (P66).

When the i50 Tridata is connected to a SeaTalk NG network, it can participate in a group illumination. You can assign it to a unit group (e.g., "Steering 1") so that all instruments in that group share the same backlight level.

Yes, the i50 Tridata is designed for flush-mount installation. The front bezel can be easily removed by pulling on the edges, allowing you to screw the unit directly to the bulkhead for a clean, aligned look with your other instruments.

If the depth display is flashing, it means the display has lost the depth sounder signal. The displayed value is the last known depth. Check your depth transducer connections at the back of the device and ensure you are not in an area with strong turbulence or highly aerated water.

No, the i50 range features push-button controls. This is intentional: it allows intuitive and reliable navigation between data pages, even in rough sea conditions or when wearing gloves, where touchscreens can reach their limits.

Yes, if you power the SeaTalk NG network or the device directly from a battery, you must install a 5-amp inline fuse (or equivalent thermal circuit breaker) on the positive wire (red) to protect your electrical installation.

It is recommended to use only a clean, damp cloth to wipe the screen. Never use abrasive products, acids, ammonia, or chemical solvents, as they could irreparably damage the LCD screen's surface treatment.

Yes, the device can operate in "Repeater" mode. If it is connected to a SeaTalk NG or SeaTalk 1 network where another instrument (or module) is already broadcasting depth and speed data, the i50 will display this information without requiring its own transducers connected at the rear.