RCR - Cititor card SD și port USB

The RCR-SDUSB is a remote card reader designed as an accessory for Raymarine Axiom multifunction displays (MFD). It extends the connectivity of these MFDs by providing an SD card slot and a USB port.

The RCR-SDUSB's SD slot is compatible with SD memory cards. For MicroSD cards, they must be inserted into an SD adapter (usually supplied with the MicroSD card) before they can be used.

The RCR-SDUSB's USB port is used to connect external USB storage devices such as USB sticks. It can also be used to charge small compatible USB devices.

No, it is important not to connect to the RCR-SDUSB USB port any device requiring an external power source. It is designed for charging small compatible devices.

The SD card slot is primarily used for loading marine electronic charts and transferring user data, such as waypoints and routes, to and from your Axiom MFD.

The RCR-SDUSB is specifically designed as a remote card reader for Raymarine Axiom series multifunction displays (MFD).

The RCR-SDUSB is designed for surface mounting. Installation requires drilling holes in the mounting surface using the provided template, then securing the unit with four self-tapping screws (not included).

For mounting the unit, you will need four self-tapping screws of the appropriate size (not included). The drill bit and screw sizes will depend on the thickness and type of mounting surface.

Yes, a mounting template (document number 87292) is provided to guide you in cutting and drilling the required holes on the mounting surface.

The RCR-SDUSB is equipped with an integrated cable 1 metre (approximately 3.28 feet) long for connection to your Axiom MFD.

The 1-meter integrated cable of the RCR-SDUSB must be routed through the mounting hole and connected to the accessory interface located at the rear of your Axiom multifunction display.

Yes, suppression ferrites are included and must be installed on the chartplotter's cable. They are designed to reduce potential interference and prevent data corruption when reading and writing to external storage.

Two of the suppression ferrites must be installed at 6 mm (0.24 in) intervals from the end of the cable connector. The third ferrite must be placed 53 mm (2.09 in) from the back of the chartplotter. Cable ties are also provided to secure them in place.

After installation, it is crucial to ensure that the cover or door of the chartplotter is firmly closed. This prevents water ingress and subsequent damage to the product.

Yes, a mounting bracket must be attached to the back of the chartplotter before inserting it into the cutout hole for installation.

The RCR-SDUSB is primarily designed to extend your Axiom MFD capabilities by providing access to electronic charts via the SD slot and allowing connection of USB storage devices or charging small devices via the USB port.

The RCR-SDUSB extends the native capabilities of Axiom MFDs by providing a remote solution for storage and connectivity needs. It enables flexible data and chart management, optimizing access to critical onboard information.

The RCR-SDUSB is not specified as being supplied with an adapter. However, most MicroSD cards are usually supplied with a suitable SD adapter, which is required for use in the RCR-SDUSB's SD slot.

The RCR-SDUSB is specifically designed as an accessory for Raymarine Axiom multifunction displays (MFD), and compatibility with other brands is not indicated.

The part number or SKU for this Raymarine RCR-SDUSB chartplotter is A80440.