Invertor 48/3000

The Victron Energy Inverter 48/3000 inverter delivers a continuous output of 3000 VA, which corresponds to 2400 W at an ambient temperature of 25°C.

This device is a pure sine wave inverter. It produces high-quality alternating current, suitable for powering all types of sensitive electronic equipment.

The Victron Energy Inverter 48/3000 inverter is designed to operate with a 48 V DC input voltage.

The inverter provides an output voltage of 230 VAC ± 2% and a frequency of 50 Hz ± 0.1%.

The integrated SinusMax technology gives the inverter a high starting power. This advantage is crucial for handling demanding inductive loads, such as refrigeration compressors or electric motors, which require a high inrush current at startup.

No, the Phoenix Inverter 48/3000 is a dedicated pure sine wave inverter. It does not include an integrated battery charger, AC transfer switch, or PowerAssist/ESS features, unlike other multifunction models from Victron Energy.

In ECO mode, the inverter switches to standby when the connected load drops below a predefined value (minimum load: 15W). Once in standby, it briefly turns back on (adjustable, default every 2.5 seconds) to check if the load has increased. If the load exceeds a predefined level, the inverter remains on.

The inverter is equipped with multiple protections to ensure its reliability and safety:

Output short-circuit protectionOverload protectionProtection against excessively high or low battery voltagesProtection against excessive temperatures (overheating)Protection against excessive DC ripple

The inverter can operate within an ambient temperature range from -40 to +65°C. It is equipped with a fan-assisted cooling system. It is important to note that a derating of 1.25% per °C is applied above 40°C.

For optimal performance, the inverter must be installed on a flat surface. It is essential to avoid any contact with water, direct exposure to sunlight, and environments that are humid or dusty. The ambient temperature must be between -20°C and 40°C (humidity < 95% without condensation).

It is essential to leave a free space of at least 10 centimeters around the inverter to ensure adequate ventilation and prevent any obstruction of the airflow. This helps avoid overheating of the device.

The inverter uses screw terminals for connecting DC battery cables, making installation easier without special tools.

Yes, a remote on/off switch can be connected to a bipolar connector provided for this purpose on the inverter.

The inverter chassis must be grounded. The ground conductor, connecting the chassis ground terminal to a reliable earth ground, must have a cross-sectional area at least equal to half that of the conductors used for the battery connection.

No, you must never connect the AC output of the inverter to another AC power source, whether it is a domestic wall outlet or a generator.

To fully utilize the inverter's capacity, it is recommended to use batteries with sufficient capacity and battery cables with an adequate cross-sectional area. If the DC cable length exceeds 1.5 meters, an additional DC fuse or circuit breaker must be installed near the battery.

Yes, this inverter offers expansion capabilities. Up to six units can be connected in parallel to increase total output power. It is also possible to configure three units for a three-phase output, to adapt the system to the specific needs of the installation.

Yes, thanks to its high starting power and SinusMax technology, the inverter is perfectly suited for starting difficult inductive loads, such as refrigeration compressors, pumps, or electric motors, which require high current at startup.