Kabel B&G WS300/700 35m

This cable is specifically designed for use with B&G wired wind sensors from the WS310 and WS700 series.

The cable is fitted with male and female Micro-C connectors. They are factory-molded to ensure a reliable and watertight connection.

No, under no circumstances should you cut this cable. The connectors are factory-molded to ensure a perfectly watertight and reliable connection. Cutting the cable would negate these advantages and could cause failures.

No, this cable is not compatible with the WS320. The WS320 is a wireless model that does not require a mast cable. This product is intended for wired WS310 and WS700 sensors.

One end of the cable connects to the wind sensor (WS310 or WS700) at the masthead. The other end plugs into the NMEA 2000 interface dedicated to the sensor, which is typically installed inside the boat.

Yes, the cable has a thermoplastic sheath designed to provide durable resistance to demanding marine conditions, including vibrations, UV exposure, and mechanical stresses from mast movements.

No, this cable does not connect directly to a multifunction display. It is used to link the wind sensor to its specific NMEA 2000 interface (connection box). It is this interface that then transmits the data to your boat's NMEA 2000 network.

No, installation is very simple. The connectors are pre-molded and the system is designed for plug-and-play connection. Simply screw the connectors together to achieve a secure and watertight connection without requiring manual wiring.

Yes, this 35-metre cable is the long-length alternative to the standard 20-metre cable, which is also available in the B&G range for WS310/WS700 sensors.

This cable is specifically designed and tested for B&G WS310 and WS700 sensors and their interface. Use with equipment from other brands is not guaranteed and not recommended.

Watertightness is ensured by the Micro-C connectors, which are factory-molded directly onto the cable. This one-piece design eliminates potential water entry points that could occur with manually assembled connectors.

This mast cable is an essential component for transmitting wind data. It connects the wired wind sensor (vane anemometer) located at the masthead to its interface to power the sensor and send wind information (speed and angle) to the boat's navigation system.

Yes, this is an NMEA 2000 cable using standard Micro-C connectors. It is however dedicated to the connection between the B&G wind sensor and its specific interface, and not for building a general NMEA 2000 backbone.

No, no specific tools are required to connect the plugs. Micro-C connectors are designed to be hand-tightened, ensuring a solid and watertight connection.

Yes, absolutely. The WS300 series includes the WS310 model. This cable is therefore fully compatible with the B&G WS310 wired wind transducer, as well as with the WS700 series sensors.