Baterija AGM 12 V 90 Ah

This battery uses AGM (Absorbed Glass Mat) technology. In this type of battery, the electrolyte (a mixture of water and sulfuric acid) is fully absorbed into fiberglass separators, making it maintenance-free and gas-free during normal use.

The main advantages of this AGM battery are:

It requires no maintenance and does not emit gas during normal use.It offers excellent high-current discharge capacity, making it ideal for engine starting.It has low internal resistance thanks to its fibreglass technology, optimizing power delivery.It has an extended service life due to the use of thicker plates.It can be installed in any position (though vertical is recommended) and is a perfect replacement for wet lead-acid batteries.

The nominal voltage of this battery is 12 Volts.

The nominal capacity of this battery, measured over 20 hours (C20), is 90 Ah.

The weight of this battery is 28 kg.

The external dimensions of this battery (length x width x height, including handles and excluding automotive-type terminals) are 330 x 173 x 220 mm.

Yes, this battery is perfectly suited for engine starting. Its AGM design provides excellent high-discharge capacity at high current levels, delivering cranking power equivalent to a 180 Ah flooded lead-acid battery.

No, thanks to its AGM technology, this battery is maintenance-free. The electrolyte is absorbed in the glass fiber, eliminating the need to check or top up the water level. It is however recommended to keep it clean and charged.

This battery is fitted with M8 / type A terminals, which are removable and compatible with all standard battery terminals.

For battery installation, it is recommended to:

Install it in an upright position.Maintain at least 1 cm of space between batteries.Keep it away from heat sources.Ensure adequate ventilation if installed in a confined space, as an explosive hydrogen gas mixture can escape in case of overcharging.

The recommended torque for terminal connections is 14.7 to 19.6 Nm.

Yes, these batteries can be connected in series or parallel. However, all connected batteries must be of the same brand, type, capacity, and state of charge. It is important not to mix new and old batteries.

Lead-acid batteries can release an explosive mix of hydrogen gas when overcharged. If the battery is installed in an enclosed space, adequate ventilation is essential to prevent the risk of explosion or fire.

Only chargers with an IUoUo characteristic must be used to charge this AGM battery.

The recommended charging voltages at 25°C are:

For float charge: 13.80 V. For absorption charge: 14.25 V (for a maximum of 5 hours).

Yes, a temperature-compensated charge is highly recommended for this battery, with a setting of -30 mV/°C.

This battery is covered by a two-year warranty.

To keep the battery in good condition and extend its lifespan:

Check the battery and its connections regularly (at least every three months) and correct any faults immediately.Keep the battery charged.Recharge the battery if its open-circuit voltage drops below 12.3 Volts.Avoid deep discharges; regular discharges beyond 50% of the rated capacity are not recommended.Recharge the battery immediately after each discharge and never discharge it below the final discharge voltage.Keep the battery dry and clean using a soft, damp cloth. Never use additives, acids, or abrasive products.Never open the battery or add acid or distilled water.