Sonda GT30-TH - transversal d'acer inoxidable ClearVü/SideVü

The GT30-TH transducer is compatible with Garmin chartplotters featuring a 12-pin connection. For seamless integration and operation, a software update of the chartplotter is required.

The Garmin GT30-TH is a through-hull stainless steel transducer that integrates ClearVü™ and SideVü™ sonar imaging technologies. It operates at frequencies of 455/800 kHz with 500W power and includes a temperature sensor. It is designed for permanent installation through the hull of your boat.

The GT30-TH transducer is specifically designed for hulls with less than 5° of deadrise (angle of heel), ensuring optimal performance without requiring a fairing block. For hulls with more than 5° of deadrise, the use of a fairing block is recommended to keep the sonar beam perpendicular to the waterline and maintain optimal signal quality.

For optimal performance, the GT30-TH transducer must be mounted in an area of clean, non-turbulent water. Here are general guidelines:

On outboard and sterndrive boats: Mount the transducer in front of and near the engine(s).
On inboard boats: Mount the transducer in front of and away from the propeller and propeller shaft.
On stepped hulls: Mount the transducer in front of the first step.
On long-keel hulls: Mount the transducer with a slight angle pointing toward the bow, parallel to the centerline.
On fin-keel hulls: Mount the transducer 25 to 75 cm (10 to 30 in) in front of the keel and no more than 10 cm (4 in) to the side of the centerline.
On displacement hulls: Mount the transducer about one-third of the waterline length from the bow, and 150 to 300 mm (6 to 12 in) to the side of the centerline.
Avoid mounting the transducer behind strakes, chines, fittings, through-hull fittings, or any other obstruction that could create air bubbles or turbulent water.

Note: The GT30-TH transducer is designed for use in fresh or salt water. Ensure the transducer face is fully submerged at all times, including when the boat is heeled or trimmed.

To reduce interference with the sonar signal of your GT30-TH transducer, take the following steps:

Electromagnetic interference (EMI): Ensure proper grounding of devices. If the transducer cable must cross a power cable, route the cables at 90 degrees to each other. You can also install a ferrite bead on the transducer cable and route it away from other powered cables.

Interference from turbulence: Mount the transducer as far as possible from any equipment or hull features (seams, chines, propeller) that could agitate the water. Areas of eroded paint on the hull often indicate turbulence zones to avoid.

Acoustic interference: Mount the transducer away from propellers, shafts, cables, other machinery, and other transducers. If using multiple transducers, space them at least 60 cm (24 in) apart.

Yes, the Garmin GT30-TH transducer is equipped with an integrated sensor that measures and displays water temperature on compatible chartplotters.

Yes, the GT30-TH transducer can be installed on a metal hull. Specific instructions are provided for preparing a metal hull, requiring the use of a file, a 13 mm (1/2 in) drill bit, and a 32 mm (1 1/4 in) hole saw for the shaft hole to ensure correct and secure installation.