Radom GMR Fantom™ 24x, blanc

To mount the GMR Fantom™ 24x radome, use the provided mounting template to drill four 9.5 mm (3/8 inch) holes. Apply anti-seize compound to the included M8 x 1.25 x 60 mm threaded rods, insert them into the radome holes, and secure with flat washers, split washers, and hex nuts. Tighten to 13.7–18.6 N·m (10–14 lbf·ft) using a torque wrench. Position the radome aligned with the bow using the arrow as a reference.

You will need a drill, a 9.5 mm (3/8 inch) drill bit, an optional 32 mm (1 1/4 inch) hole saw for cables, a 4 mm (5/32 inch) Allen key, a 13 mm (1/2 inch) wrench, a torque wrench, and marine sealant.

Never remove the inline fuse holder. Connect the red wire to the positive terminal (+) of the battery and the black wire to the negative terminal (-). Turn the locking ring clockwise to secure the cable to the locking power port. Use the appropriate wire gauge for extensions: 16 AWG up to 2 m, 14 AWG up to 4 m, 12 AWG up to 6 m.

Yes, it connects directly via a Garmin BlueNet cable to an open network port on a Garmin BlueNet chartplotter or the Garmin BlueNet 20 switch for optimal performance.

Use the Garmin Marine Network adapter cable (ref. 010-12531-01) to connect the radome's BlueNet cable to a Garmin Marine Network chartplotter port or to the GMS 10 port expander. Tighten the locking rings.

Yes, update the Garmin chartplotter software during installation. See the chartplotter manual on support.garmin.com for instructions.

The radome operates from 10 to 32 Vdc. Check the input voltage with a multimeter if an error code 1004 or 1005 appears.

It is compatible with recent Garmin chartplotters via BlueNet or Marine Network with an adapter. Check software compatibility and update for optimal integration.

From -15 to 70 °C (5 to 158 °F). If error code 1013 (high temperature) appears, check the installation temperature.

Solid red: Booting, should transition to blinking green shortly.Blinking green: Operating normally.Blinking orange: Software update in progress.Blinking red: Error, check chartplotter.

Yes, it uses ultra-fast short-pulse technology for long-range detection with rapid refresh rates.

Check the drive belt for wear or disconnection, inspect the motor and antenna gears, and test the cables. Replace defective parts if necessary after following universal troubleshooting steps.

Yes, if the radome is not aligned with the bow, adjust the front-of-boat offset via the chartplotter after installation.

M8 x 60 mm bolts are suitable for thicknesses from 5 to 30 mm. For thicknesses over 30 mm, use longer bolts.

For optimal performance and to avoid injury or damage, installation by a qualified marine installer is recommended.