AC Master inverter 24/1500 (230/50-60 Hz) EU (Schuko)

The Mastervolt AC Master 24/1500 inverter delivers a continuous output of 1500 W at 25 °C and 40 °C (cos phi 1). It can also handle peak loads up to 1730 W for 1 minute and 2650 W for 1 second, which is useful for devices requiring a startup surge.

This inverter uses pure sine wave technology. It provides reliable 230 V AC power at 50/60 Hz, protecting sensitive equipment and avoiding the humming noise often associated with modified sine wave inverters.

The inverter has compact dimensions of 248 x 421 x 83 mm (height x width x depth). Its weight is 4.2 kg, making installation in various marine or mobile environments straightforward.

The Mastervolt AC Master 24/1500 inverter maintains a high efficiency of 94%. This high efficiency minimizes energy losses and optimizes battery autonomy.

Yes, this inverter includes an energy management system with an automatic economy mode. This mode extends battery life by reducing power consumption without load, dropping from less than 1.0 A to less than 0.05 A for a 24 V system.

The Mastervolt AC Master 24/1500 inverter is suitable for ambient temperatures from -20 °C to 60 °C. Note that a power derating applies above 40 °C (at 60 °C, power is reduced to 40 % of its nominal capacity).

Yes, the inverter has overload protection. In case of overload, a red LED lights up. You must then reduce the load and/or check the AC wiring for any short circuits, then manually reset the inverter by turning off and back on the main switch.

In normal operating mode (ON mode), the inverter's no-load power consumption is less than 1.0 A for a 24 V system. In energy-saving mode, this consumption is significantly reduced to less than 0.05 A.

For the AC Master 24/1500 model, the minimum recommended DC cable cross-section is 25 mm² (equivalent to 4 AWG). It is critical to comply with this specification to avoid excessive voltage drops, ensure safety, and guarantee optimal inverter operation.

For the AC output connection of the AC Master 24/1500 inverter (for 12 V and 24 V models), the minimum recommended cable cross-section is 1.00 mm² (equivalent to 17 AWG). This ensures safe and efficient distribution of AC power to your devices.

For a secure installation, the ground point of the AC Master chassis must be connected to the central ground point of the vehicle or boat. This connection is essential for protection against electric shocks and proper system operation.

Yes, the inverter can be connected to a remote control panel or a remote switch. The remote control terminal also provides an alarm contact function (dry contact) to signal faults.

It is imperative never to use the AC Master in any location where there is a risk of gas or dust explosions. The safe ambient temperature range for installation is -25 °C to 60 °C, but ensure adequate ventilation.

This inverter is specifically designed to work with 24 V battery systems. It converts this DC voltage into AC power to supply your devices.

Yes, the inverter output frequency is adjustable via a DIP switch (DIP switch 3). The available options are 50 Hz or 60 Hz, allowing the inverter to be adapted to the requirements of your devices or your region.

A slowly flashing red LED indicates that the DC input voltage is too low. This can be caused by voltage drop in the DC cables (cables too long or undersized), loose or corroded connections, or a discharged battery. It is recommended to check the wiring, tighten the connections, and recharge the battery if necessary.

Yes, this inverter provides galvanic isolation. This feature ensures enhanced system safety by electrically isolating the input and output circuits, protecting users and connected equipment from leakage currents or interference.