Ūdensizturīgs slēdžu izslēgšanas panelis – pelēks, 6 pozīcijas

This circuit breaker panel is designed to provide switching, illuminated ON-state indication, and overcurrent protection for six electrical circuits. It eliminates the need for separate fuses for each circuit, simplifying installation and maintenance of onboard electrical systems.

Yes, the front panel is rated IP66 when mounted with its gasket, providing protection against powerful water jets. It also features silicone caps for the circuit breakers and an EPDM gasket to specifically prevent water infiltration.

The panel surface is made of UV-stabilized polycarbonate/ABS, fire-retardant and corrosion-resistant. This composition ensures enhanced durability in demanding marine environments.

This panel is a 6-position model, meaning it can control and protect up to six separate electrical circuits.

Each circuit breaker integrated into this panel has a nominal rating of 15A.

No, this panel integrates circuit breakers that provide overcurrent protection, eliminating the need for separate fuses for each circuit.

The nominal operating voltage of this circuit breaker panel is 12V DC.

The maximum continuous total current that this panel can support is 45A.

This specific circuit breaker panel model is gray.

Yes, a set of 15 square-format circuit labels is included with the panel. These labels are easy to replace.

Yes, illuminated circuit breakers provide a light indication of the 'ON' state, making it easy to see which circuits are active.

The panel dimensions are as follows:

Height: 169.67 mm (6.68 in)Width: 119.38 mm (4.70 in)Depth: 44.45 mm (1.75 in)

Circuit breakers use 1/4-inch male quick-connect terminals to simplify wiring.

A two-wire connection with #10 (M5) ring terminals is required to power the entire panel.

The recommended torque values are:

Maximum torque for terminal studs: 2.25 N·m (20 in-lb)Maximum torque for mounting screws: 1.13 N·m (10 in-lb)

Yes, stainless steel mounting screws #6 x 5/8" are included in the packaging.

This panel must never be installed where flammable vapors could accumulate, such as in an engine room or a propane compartment.

To reset a circuit breaker, first move the switch to the OFF position, then move it to the ON position.

Yes, thanks to its standard dimensions and low profile, this panel is designed to be easily integrated or replaced in existing applications.

No, common busbars are sold separately and are not included with the circuit breaker panel.