Airmar B150M – bronzas caurlaides sonda 300W (95–155 kHz) ar 0° slīpuma elementu + temperatūras sensors – (8 kontakti)

This Airmar B150M CHIRP transducer operates in the mid-frequency band, ranging from 95 kHz to 155 kHz.

No, this transducer with a bronze housing is recommended for fibreglass or wooden hulls. It must never be installed on a metal hull due to the risk of electrolytic corrosion.

This Airmar B150M transducer has a 0° tilted element. This means it is designed for hulls with a deadrise angle between 0° and 7° at the mounting location.

Yes, this Airmar B150M transducer is equipped with a fast-response water temperature sensor.

This transducer is fitted with an 8-pin connector, compatible with the relevant Garmin devices.

To install this transducer, a 51 mm (2 inches) diameter hole must be drilled from the outside of the hull. For fiberglass cored hulls, a 60 mm (2-3/8 inches) hole is required from inside the hull.

CHIRP tilted-element transducers provide several advantages:

The ceramic elements are tilted inside the housing to compensate for the hull’s deadrise angle, ensuring the beam is directed downward.They maximize echo returns and eliminate the need for a fairing block.Their low-profile design protrudes only 6 mm below the hull, making them ideal for towed or lifted boats.They deliver superior resolution, precise fish detection, and improved bottom-finding capability at high speeds.

The housing and nut of this depth sounder are made of bronze alloy. The cap is made of impact- and chemical-resistant plastic.

The ideal mounting location must meet the following criteria:

The water under the hull must be smooth, with minimal bubbles and turbulence.The depth sounder must remain continuously immersed in water.The depth sounder's beam must not be obstructed by the keel or propeller shaft.Choose a location away from interference sources (propeller, other machinery, other sounders, cables).For CHIRP sounders, mount it in a cool, well-ventilated spot away from the engine to prevent overheating.

Yes, it can be installed on a cored fiberglass hull. However, this requires additional steps to seal the hull core to prevent water ingress, using fiberglass and resin, or a cylinder, wax, tape, and casting epoxy resin.

The -3 dB beam width of this transducer varies with frequency:

Approximately 26° at 100 kHz.Approximately 20° at 130 kHz.Approximately 17° at 155 kHz.

Mid-frequency offers a good balance: it allows deeper sounding than high frequencies while providing better resolution than low frequencies. It also delivers a wider beam than high frequencies, increasing coverage beneath the boat and the chances of finding fish, with clear images even at higher boat speeds.

Yes, applying water-based antifouling paint is mandatory on the depth sounder if the boat is used in saltwater, to prevent marine growth.

No, it is imperative never to install a metal housing (such as bronze) on a vessel with a positive ground system, as this can cause electrolytic corrosion.