Bezvadu kamera Garmin GC™ 100

Installing the GC™ 100 camera involves several steps:

Mounting: Use a 3.2 mm (1/8 in) drill bit to drill a pilot hole. Secure the camera mount to the mounting surface using the provided screw. Insert the camera into its housing, close the front of the housing, and tighten the tamper-proof side screws with the included tool.Considerations for mounting: Install the camera in a location where it will not be submerged and within 76 m (250 ft) of a chartplotter. Test the desired location before permanent installation. Ensure the cable can be easily connected and that the camera will not be damaged or pose a hazard.Power connection: Route the power cable to the power source and to the device. Connect the red wire to the battery’s positive (+) terminal and the black wire to the negative (-) terminal. Do not remove the inline fuse holder and ensure the correct fuse is in place.

The GC™ 100 camera is designed to pair with compatible Garmin chartplotters that have Wi-Fi capability. Before connecting the camera, you must set up the Wi-Fi network on your Garmin chartplotter.

The GC™ 100 camera must be mounted within 76 meters (250 feet) of a chartplotter. Actual range may vary depending on installation location and obstacles between the camera and the chartplotter.

Yes, the GC™ 100 camera is built to withstand marine environments. It has an IEC 60529 IPX6/IPX7 waterproof rating, meaning it can handle accidental water exposure up to 1 meter for 30 minutes. Its operating temperature range is from -20 °C to 60 °C (-4 °F to 140 °F), ensuring reliability in various weather conditions.

To turn off the GC™ 100 camera, press and hold the button for 3 seconds. Note that if you hold the button for more than 10 seconds, the camera will reset. After installation and pairing with the chartplotter, the camera typically turns on when the chartplotter is powered on.

The GC™ 100 camera requires an input voltage of 10 to 30 Vdc, with a maximum current draw of 1.5 A. It also features an internal rechargeable battery that can be charged via the camera’s powered mount or, alternatively, by connecting the camera to a power source using a Micro-USB cable (not included).

To pair the GC™ 100 camera with a compatible Garmin chartplotter, follow these steps:

Ensure the camera is within 76 meters (250 feet) and has a clear line of sight to the chartplotter.Configure the chartplotter's Wi-Fi network. Refer to your chartplotter's manual for details.Press the camera button three times. The LED indicator will start flashing blue.On the chartplotter, select Settings > Communications > Wireless Devices > Garmin Camera > Start.The chartplotter will display a notification once pairing is complete. It may be necessary to charge the camera's internal battery before pairing.

The status LED on the GC™ 100 camera indicates its operational status through different flashing sequences:

Green (three flashes): The camera is powering on.Red (three flashes): The camera is powering off.Blue (one flash per second): The camera is attempting to connect to a chartplotter via Wi-Fi.Orange (one flash per second): The camera battery is not sufficiently charged to stream video.