Montāžas balsts LiveScope™ Force® Kraken

This bracket is designed to integrate LiveScope transducers compatible with the Garmin Force Kraken electric motor. It ensures a clean and protected installation of the LiveScope transducer cable by routing it through the motor shaft, minimizing the risk of damage during motor stowage or deployment.

The mount is specifically compatible with Garmin LiveScope transducers LVS32, LVS34 and LVS62.

No, this mount is exclusively designed for use with the Garmin Force Kraken electric motor.

Once mounted with this bracket, the LiveScope transducer can operate in all three display modes: forward, rearward, and perspective, with no compromise on performance.

The kit includes all mounting hardware: screws, washers, O-rings, seals, 2.5 mm, 5 mm and 6 mm Allen keys, a ring spanner and marine grease.

Yes, it is mandatory to use exclusively the hardware included in this kit. This prevents potential damage to the engine and the transducer, and ensures correct and safe operation of the system.

Before performing any maintenance or installation work, you must always disconnect the electric motor from the battery. It is also recommended to read all installation instructions before starting.

In addition to the included Allen keys, eyelet wrench, and marine grease, you will need a Phillips screwdriver size #2, diagonal cutting pliers, electrical tape, cable ties, and a torque wrench.

You can mount your LiveScope transducer on either the starboard or port side of your Force Kraken electric engine shaft.

No. Once the LiveScope transducer is mounted, the outboard can only be stored in one direction. You must choose which side the propeller faces when stored before installation, as this cannot be changed afterward.

The mount routes the LiveScope transducer cable through the Force Kraken engine shaft, protecting it from damage risks that may occur during stowage or deployment of the engine.

Yes, the kit includes specific mounting buttons for each transducer model: a small button for the LVS32, a medium button for the LVS34, and a large button for the LVS62, ensuring proper and secure mounting of your transducer to the bracket.

Yes, you must firmly tighten all adjustment knobs of the LiveScope transducer mount before each use to ensure probe stability and optimal performance.

Yes, before opening the shaft housing, you must disconnect the engine from its power source. Failure to do so may result in electric shock or engine damage.

When removing or installing the engine, it is crucial to pull on the cables themselves and not on the connectors. You must also avoid supporting the engine solely by the cables to prevent damage to the connections.

Yes, it is recommended to apply a thin layer of marine grease, supplied in the kit, to the new blue and black seals before installing them. This ensures proper sealing and extends the lifespan of the seals.

Approximately 15 to 20 cm (6 to 8 inches) of LiveScope cable should be left between the shaft adapter and the transducer. This allows for easy repositioning and switching display modes after installation.

Yes, apply medium-strength thread-locking compound, such as LOCTITE 243™, to the threads of the six engine mounting holes. This is essential to maintain a secure connection between the shaft base and the engine and prevent water ingress.

Align the prominent tab on the puck with the recess on the shaft adapter. Then secure it using the included hex-head screw and washer, tightening the screw to 7 N·m (62 lbf-in) with a torque wrench.

No, the LiveScope™ Force® Kraken mounting bracket is a mounting accessory. It is designed to allow mounting a LiveScope transducer (sold separately) on the Force Kraken electric motor. The transducer itself is not included in this kit.