AGM baterija 6 V 260 Ah

This Mastervolt battery uses AGM (Absorbent Glass Mat) technology. It is designed as a sealed, maintenance-free energy storage solution, offering a reliable and cost-effective alternative to traditional lead-acid batteries. It does not require adding acid or distilled water.

This Mastervolt AGM battery has a nominal voltage of 6V and a capacity of 260Ah.

The weight of this Mastervolt AGM battery is 35.5 kg.

No, Mastervolt AGM batteries are supplied ready for use and maintenance-free. It is never necessary to add acid or distilled water thanks to their sealed valves.

The permitted operating temperature range for this battery is –20 to 55°C. The recommended nominal temperature to maximize battery life is 25°C (or 5 to 35°C for nominal use).

To clean the battery, use only a soft, damp cloth. Never use additives, acids, or abrasive products.

The electrolyte is highly corrosive. Under normal conditions, contact with the electrolyte is impossible as the battery is sealed. However, if the casing is damaged, the electrolyte may leak. In case of contact, rinse immediately and thoroughly with water and consult a doctor.

In case of overcharging, lead-acid batteries can release an explosive mixture of hydrogen gas. It is essential to ensure adequate ventilation if batteries are installed in a confined space to prevent explosion and fire hazards.

This battery must be installed in an upright (vertical) position.

A space of more than 1 cm (or >0.5 inch) should be left between batteries for optimal heat dissipation.

The recommended torque for screw connections is 16.0 to 20.5 Nm (or 145 to 180 InLbs) to ensure reliable and secure electrical conductivity.

During installation, ensure all loads and chargers are turned off. Use insulated tools, appropriately sized and reliable cable lugs and terminals. Tighten all connections firmly and use battery terminal insulators. Connect the negative cable last. Do not smoke and avoid sparks near the battery.

Yes, it is important to clean the battery terminals before connecting them to ensure good electrical conductivity.

It is important not to install the battery near heat sources.

This battery must be charged exclusively with chargers featuring an IUoUo characteristic.

At 25°C, the recommended voltage settings are 6.90V for float charge and 7.13V for absorption charge, with a maximum duration of 5 hours for the latter. A temperature compensation of –15mV/°C is highly recommended.

Yes, these batteries can be connected in series or parallel. However, it is crucial that all batteries in the configuration are of the same brand, type, capacity, and state of charge. Never mix old and new batteries in the same setup.

The recommended maximum charge current is 30% of the nominal capacity at C10.

To avoid damaging the battery and extend its lifespan, it is recommended to avoid deep discharges (regularly beyond 50% of the rated capacity). The battery must be recharged immediately after discharge and must never be discharged below its final discharge voltage.

Opening the valves on the Mastervolt AGM battery will void the warranty. It is imperative never to open these valves.