Lādētāja pārveidotājs Magic 24/12 - 20A

The Magic 24/12 - 20A is a versatile device primarily used to convert 24V DC to a stable 12V output. It can also function as a 3-stage battery charger or as a dimmer for your lighting.

Yes, this model provides full galvanic isolation between input and output. This protects sensitive electronic equipment, such as communication or transmission gear, from electrical interference.

When configured in charger mode, it is compatible with a wide range of 12V batteries, including:

Flooded lead-acid (wet)GelAGMSpiral cellTractionLithium-Ion

The converter delivers a nominal and maximum output power of 300 W, with a maximum output current of 20 A (or 16 A when used in battery charger mode).

Yes, it is perfectly possible to configure multiple converters in parallel. This feature is ideal if you have many consumers on board, as it allows you to reach capacities exceeding 100 amperes.

To ensure a secure installation, the screw terminal on the device is designed to accept cables with a maximum cross-section of 16 mm² (AWG5).

The dimmer function allows you to regulate the intensity of your 12V lighting very efficiently, without energy loss in the form of heat. It is activated using an external momentary switch and requires specific adjustment of the internal DIP switches.

It is recommended to install it in a well-ventilated area, protected from rain, moisture, and dust. Mount it in a vertical position with the cables pointing downward. Caution: never install it directly above the batteries to avoid damage from corrosive fumes.

Yes, although it does not have a native MasterBus port, it is compatible and can be integrated into your network via an optional MasterBus serial interface.

Yes, the nominal output voltage is 13.6 V, but it can be precisely adjusted between 10 V and 15 V using a PC and the MasterAdjust software.

The converter has an IP21 protection rating. It is therefore protected against vertically falling water droplets, but it must be installed indoors in a dry environment.

You have two methods for setup:

Use the 4 DIP switches located inside the housing for basic settings.Program it in advanced mode via a computer using the MasterAdjust software.

The device uses high-frequency switching technology, delivering excellent efficiency over 90% at full load, with peaks reaching 92%.

Yes, it is equipped with automatic protections against overload and overheating. Additionally, its cooling is ensured by silent and maintenance-free variable-speed fans.

The voltage range depends on the mode of use:

In standard converter mode: 19 to 32 V.In 3-stage battery charger mode: 24 to 32 V.

Yes, for safety reasons, it is essential to include a fuse on the positive cable. This fuse must be placed as close as possible to the source battery.

When configured to recharge a 12 V battery (3-stage smart charger mode), the device delivers a maximum charging current of 16 A.

This converter is compact and lightweight. It measures 227 x 154 x 81 mm (Height x Width x Depth) and weighs 1.8 kg in total.

No, if your goal is to use it solely as a stabilized 13.6 V power supply, the factory settings are perfectly suitable and you do not need to adjust the DIP switches.

Warning: the device has an internal non-replaceable input fuse. Reverse polarity (swapping positive and negative wires) will irreparably damage the converter. Always check your connections before powering on.