Sinusoidālais pārveidotājs Mass Sine 12/2000 (230V/50Hz)

This is a pure sine wave inverter that converts the 12V DC voltage from your battery bank into 230V AC (50Hz). It is designed to provide a stable and reliable power supply for sensitive electrical equipment, even in the most demanding marine environments.

The Mass Sine 12/2000 delivers a continuous power output of 1800 W at an ambient temperature of 40 °C, and a 30-minute power output (P30) of 2000 W.

It can handle very high startup peaks up to 4000 W. This peak capacity is ideal for starting complex and power-hungry electrical equipment smoothly.

For optimal and safe operation of the Mass Sine 12/2000, use a 12V battery bank with a capacity greater than 200 Ah.

Installation requires a 250 A DC fuse (slow-blow type) to effectively protect the wiring between the inverter and the battery.

You must use cables with a minimum cross-section of 70 mm² to connect the inverter to your 12 V battery bank to prevent overheating or voltage drop.

No. Thanks to its high-frequency switching technology, the inverter delivers high efficiency (92 %) while avoiding irritating electrical humming and buzzing.

Idle power consumption is very low. It is 480 mA (6 W) in normal mode, and drops to just 50 mA (0.6 W) when in power-saving mode.

Yes, the Mass Sine is MasterBus-compatible. To integrate it into the network and control it via a display (such as the EasyView 5), you must use a MasterBus Inverter interface or an AC power analyzer.

Yes. It includes full protection against overheating, overload, short circuits, as well as abnormally high or low battery voltages.

It must be installed in a closed, properly ventilated compartment, protected from rain, humidity, condensation, and dust. Never cover the ventilation openings to prevent overheating of the device.

The lights indicate the device's status:

Slow flashing (with "inverter on"): the inverter is overloaded and has entered standby before automatically restarting.
Fast flashing: the device has shut down completely after multiple attempts and requires a manual restart via the switch.

The inverter has the following physical specifications:

Dimensions: 420 x 318 x 130 mm (Height x Width x Depth)Weight: 14.6 kg

The converter complies with IP23 ingress protection standard, protecting it against solid objects larger than 12.5 mm and rainwater at angles up to 60°.

No, you must never connect the AC output (alternating current) of the inverter to an incoming AC source such as a generator or shore power, as this may cause serious damage.

Yes, Mastervolt’s Masterswitch and Systemswitch switching systems can be connected to this converter to enable automatic selection of the desired power source.

The inverter automatically stops if battery voltage drops to 10 V (± 0.5 V) to prevent deep discharge. It restarts automatically when voltage rises back to 11 V (± 0.5 V).

The converter can operate within an ambient temperature range from -25 °C to 80 °C. However, a power derating applies automatically for temperatures above 40 °C.

Yes, the Mass Sine must be equipped with a grounding conductor connected to the AC output earth terminal, in compliance with local electrical standards to ensure installation safety.