MasterBus kabel 100 m

The Mastervolt MasterBus 100m cable is the main communication cable for your MasterBus network. It handles both data transfer and power supply for compatible peripheral devices, simplifying installation by eliminating the need to run separate cables for power and data.

This MasterBus cable is sold in a 100-meter reel. This allows you to cut the exact length required for your installation, whether for a small boat or a large vessel needing an extended network.

No, the MasterBus 100m cable is supplied as a bulk roll without connectors. It is designed to be cut to length. To connect it, you must use a DIY connector kit, sold separately by Mastervolt.

Yes, absolutely. The MasterBus cable is designed to carry both data and low-voltage power to peripheral devices on the MasterBus network. This is one of its main advantages.

This cable is compatible with all Mastervolt products that use the MasterBus communication protocol. Most of these products come with two MasterBus ports as standard, making daisy-chaining straightforward. For devices without built-in ports, a specific interface may be required.

Installation involves uncoiling the reel, cutting the required cable length, then attaching the connectors using a MasterBus connector kit (sold separately). The cable then connects directly to the MasterBus ports on your devices. It is recommended to follow your MasterBus network wiring diagram for optimal daisy-chaining.

This MasterBus cable is specifically designed for Mastervolt's proprietary protocol. Unlike a standard network cable (Ethernet), it carries both data and electrical power for MasterBus network devices. It is also built to withstand marine conditions.

Yes, the MasterBus network operates on a daisy-chain topology (series connection). Each compatible device has two MasterBus ports, allowing you to link equipment one after another. This 100m cable gives you the flexibility to cover long distances between devices.

The MasterBus cable is designed for use in marine environments. While it is not specifically designed to be submerged, it resists moisture and typical salt spray found on a boat. For runs through highly humid areas, it is advisable to protect it with suitable sleeves.

This cable requires MasterBus-specific connectors. Mastervolt offers a DIY connector kit (reference to be verified) that includes the plugs needed to terminate the cable ends after cutting it to the correct length.

Yes, this product is covered by the statutory conformity warranty. For details on specific warranty conditions, please refer to the general sales terms or contact our customer service.

Yes, that's the advantage of this 100-metre reel. You can cut the cable to the exact length required for each segment of your network. Simply install the appropriate connectors at both ends.

Yes, the MasterBus cable is the standard communication link between all Mastervolt equipment, including battery chargers, inverters, smart batteries, and control panels. It enables centralized energy management on board.

The MasterBus network can support a large number of devices, but there is a practical limit related to the total cable length and the electrical power consumption of the peripherals. For very complex installations, it is recommended to consult the Mastervolt installation manual or a professional installer.

Although designed for the marine environment, this cable can technically be used in other environments such as motorhomes or off-grid solar installations using Mastervolt equipment. It is important to comply with the electrical safety standards applicable to the intended use.

The exact diameter of the cable is not specified in the provided information. For installation in conduits or cable glands, refer to the official Mastervolt datasheet or measure the cable upon receipt.

If you don’t need 100 meters, Mastervolt also offers MasterBus cables pre-terminated in shorter lengths (e.g., 0.2 m, 0.5 m, 1 m, 3 m, 6 m, 10 m, 15 m, 25 m). These are more practical for small extensions or local connections.