Brezžični senzor rotacije jambora

The T221 sensor requires an existing Micronet system and specific components to function correctly. You will need the following:

A Micronet display capable of configuring the compass (e.g., Digital, Dual Digital, or Remote models, but NOT the Analogue display).A wireless wind transducer Micronet.In addition to these two devices, one of the following combinations is also required:A hull transducer T121 and a compass T909.A STng heading source (such as an EV-1) and a Micro-Talk gateway.

The Raymarine T221 wireless mast rotation sensor is designed specifically for sailboats equipped with rotating masts. Its primary function is to provide essential correction for apparent wind angle data. It ensures that wind information displayed on Micronet displays is accurate, regardless of mast rotation, which is critical for performance optimization.

For optimal performance, the T221 sensor should be installed at the front of the mast, less than 1.5 meters above the deck. The location must be free from magnetic interference and provide the solar panels with an unobstructed view of the sky. The mount can be permanently secured with non-magnetic rivets or screws, or temporarily attached using the supplied Velcro strap. Integration into the network is done via self-networking.

To ensure the accuracy of the T221 sensor, calibration is required. Here are the main steps:

Secure the mast along the boat's longitudinal axis.In open water, select the compass configuration page on a Micronet display and note the displayed deviation.Perform a deviation correction turn until the display shows 'calibration complete'.For systems with T121 and T909 only, check the displayed deviation. If it has changed by more than 1° compared to the noted value, repeat the turns. If the deviation is stable, your system is correctly calibrated.Exit the configuration on the Micronet display and unlock the mast from its longitudinal position.

You can view the battery level of the T221 mast rotation sensor and the solar charge rate from a compatible Micronet display. Go to the MAST® page located in the Health chapter of your screen. If the sensor's battery level becomes low, the "Mast Low Batt" alarm will be displayed.

The T221 sensor is compatible with Micronet displays that offer compass configuration capability. This specifically includes the Digital, Dual Digital, and Remote models. It is NOT compatible with the Micronet Analogue display.

Using a mast rotation sensor, such as the Raymarine T221, is crucial for sailboats equipped with rotating masts. Without this sensor, the apparent wind angle data would be skewed by the mast's rotation. The T221 ensures wind data remains accurate at all times, enabling better sail trim optimization and significantly improving boat performance, especially during regattas or high-speed cruising with specific rigging.

Yes, the chosen location for installing the T221 sensor must be free of magnetic disturbances. Most materials such as stainless steel, aluminum, carbon, and brass generally do not cause magnetic disturbances. It is important to select a spot where these types of materials would not be likely to interfere with the sensor's operation.