Suport de muntatge LiveScope™ Force® Kraken

This bracket is designed to integrate LiveScope transducers compatible with the Garmin Force Kraken electric motor. It ensures a clean and protected installation of the LiveScope transducer cable by routing it through the motor shaft, minimizing the risk of damage during motor stowage or deployment.

The mount is specifically compatible with Garmin LiveScope transducers LVS32, LVS34, and LVS62.

No, this mount is exclusively designed for use with the Garmin Force Kraken electric motor.

Once mounted with this bracket, the LiveScope system allows the sonar to operate in all three display modes: forward, rearward, and perspective, without compromising performance.

The kit includes all mounting hardware, including screws, washers, O-rings, seals, 2.5 mm, 5 mm, and 6 mm Allen keys, an eyelet wrench, and marine grease.

Yes, it is mandatory to use exclusively the hardware included in this kit. This avoids potential damage to the engine and the transducer, and ensures correct and safe operation of the system.

Before performing any maintenance or installation work, you must always disconnect the electric motor from the battery. It is also recommended to read all installation instructions before starting.

In addition to the included Allen keys, eyelet wrench, and marine grease, you will need a Phillips screwdriver (size #2), diagonal cutting pliers, electrical tape, cable ties, and a torque wrench.

You can mount your LiveScope transducer on the starboard or port side of the shaft of your Force Kraken electric motor.

No, once the LiveScope transducer is mounted, the engine can only be stored in one direction. You must choose which side you want the propeller to face when stowed before installation, as this cannot be changed afterward.

The mount is designed to route the LiveScope transducer cable through the Force Kraken engine shaft, protecting it from potential damage that could occur during stowage or deployment of the engine.

Yes, the kit includes mounting buttons specific to each transducer model: a small button for the LVS32, a medium button for the LVS34, and a large button for the LVS62, ensuring secure and proper mounting of your transducer to the bracket.

Yes, you must firmly tighten all the adjustment knobs on the LiveScope transducer mount before each use to ensure probe stability and optimal performance.

Yes, before opening the shaft housing, you must disconnect the engine from its power source. Failure to do so may result in electric shock or damage to the engine.

When removing or installing the engine, it is crucial to pull on the cables themselves, not on the connectors. The engine should also not be supported solely by the cables to prevent damage to the connections.

Yes, it is recommended to apply a thin layer of marine grease, supplied in the kit, to the new blue and black seals of the engine before installation. This ensures proper sealing and extends the lifespan of the seals.

It is recommended to leave approximately 15 to 20 cm (6 to 8 inches) of LiveScope cable between the shaft adapter and the transducer. This allows for easy repositioning and changing display modes after installation.

Yes, you must apply a medium-strength thread-locking compound, such as LOCTITE 243™, to the threads of the six engine holes. This is essential to maintain a solid connection between the shaft base and the engine and prevent water infiltration.

Align the prominent tab on the puck with the recess on the shaft adapter. Then secure it using the included hex-head screw and washer, tightening the screw to 7 N·m (62 lbf·in) with a torque wrench.

No, the LiveScope™ Force® Kraken mounting bracket is a mounting accessory. It is designed to allow mounting a LiveScope transducer (sold separately) on the Force Kraken electric motor. The transducer itself is not included in this kit.