RCR - Lector de targeta SD i port USB

The RCR-SDUSB is a remote card reader designed as an accessory for Raymarine Axiom multifunction displays (MFD). It extends the connectivity of these MFD by providing an SD card slot and a USB port.

The SD slot of the RCR-SDUSB is compatible with SD memory cards. For MicroSD cards, they must be inserted into an SD adapter (usually supplied with the MicroSD card) before they can be used.

The USB port on the RCR-SDUSB is used to connect external USB storage devices, such as USB flash drives. It can also be used to charge small compatible USB devices.

No, it is important not to connect to the USB port of the RCR-SDUSB any device requiring an external power source. It is designed for charging small compatible devices.

The SD card slot is primarily used for loading marine electronic charts and transferring user data, such as waypoints and routes, to and from your Axiom MFD.

The RCR-SDUSB is specifically designed as a remote card reader for the Axiom series multifunction displays (MFD) from Raymarine.

The RCR-SDUSB is designed for surface mounting. Installation requires drilling holes in the mounting surface using the provided template, then securing the unit with four self-tapping screws (not included).

To assemble the unit, you will need four self-tapping screws of the appropriate size (not included). The drill bit and screw size will depend on the thickness and type of the mounting surface.

Yes, a mounting template (document number 87292) is provided to guide you in cutting and drilling the necessary holes in the mounting surface.

The RCR-SDUSB comes with an integrated cable that is 1 meter (approximately 3.28 feet) long for connecting to your Axiom MFD.

The 1-meter integrated cable of the RCR-SDUSB must be routed through the mounting hole and connected to the accessory interface located at the rear of your Axiom multifunction display.

Yes, suppression ferrites are included and must be installed on the card reader cable. They are designed to reduce potential interference and prevent data corruption when reading and writing to external storage.

Two of the suppression ferrites must be installed at 6 mm (0.24 in) intervals from the end of the cable connector. The third ferrite must be placed 53 mm (2.09 in) from the back of the chartplotter. Cable ties are also provided to secure them in place.

After installation, it is crucial to ensure the card reader cover or door is firmly closed. This prevents water ingress and subsequent damage to the product.

Yes, a mounting gasket must be attached to the back of the chartplotter before inserting it into the cutout hole.

The RCR-SDUSB is primarily designed to extend your Axiom MFD capabilities by providing access to electronic charts via the SD slot and allowing connection of USB storage devices or charging of small devices via the USB port.

The RCR-SDUSB enhances the native capabilities of Axiom MFDs by providing a remote solution for storage and connectivity needs. It enables flexible data and chart management, optimizing access to critical onboard information.

The RCR-SDUSB is not specified as being supplied with an adapter. However, most MicroSD cards are generally supplied with a suitable SD adapter, required for use in the SD slot of the RCR-SDUSB.

The RCR-SDUSB is specifically designed as an accessory for Raymarine Axiom multifunction displays (MFD) and its compatibility with other brands is not indicated.

The part number or SKU of this Raymarine RCR-SDUSB chartplotter is A80440.