Lewmar VX2+ 12 V 1000 W geared motor with relay

This is a specific spare part, a gearmotor, designed for Lewmar VX2+ series windlasses. It combines a 1000 W electric motor and a gear reduction system, also including a relay.

This gearmotor has a power output of 1000 W (Watts).

This gearmotor operates at a voltage of 12 V (Volts).

Yes, the relay is integrated directly into the gearmotor, which simplifies installation.

The gearmotor has an IP67 protection rating. This means it is fully protected against dust and can be temporarily submerged without water ingress.

This gearmotor is specifically compatible with Lewmar VX2+ windlasses.

This gearmotor is a spare part designed specifically for Lewmar VX2+ windlasses. Using it with windlasses from other brands is not recommended and could lead to compatibility or performance issues.

No, this gearmotor is designed to operate only with a 12 V power supply. It is not compatible with a 24 V installation.

For a typical installation, you will need the following tools:

Drills (10 mm, 14 mm, 18 mm)Hole saw (46 mm)Crimping pliers / Wire stripperAppropriate electrical cable and crimp terminalsMarine sealant

Lewmar recommends a minimum deck thickness of 40 mm (1 1/2”). For thicker decks, a longer shaft may be required.

It is essential to allow sufficient vertical drop space for the chain or rope. A minimum of 300 mm (12”) is required to prevent jams.

Yes, it is critical to apply suitable marine sealant to the edges of freshly cut holes in the deck to prevent water absorption and ensure optimal watertight integrity.

Yes, it is recommended to lightly grease the drive shaft and all moving parts before assembling the gearbox to the windlass. Ensure the drive key is properly seated.

Before starting the electrical installation, ensure that the boat's battery power is disconnected. The electrical installation must be performed by a qualified electrical engineer.

Lewmar recommends using a cable with a rated insulation temperature of 90°C or higher. Installation must comply with relevant regulations and standards, such as ISO 10133.

This gearmotor has a power output of 1000 W at 12 V, which corresponds to a current of approximately 83.3 amps. The cable cross-section must be determined based on the total cable length (round trip from the battery) and the current. It is the installer's responsibility to confirm the capacity and voltage drop for the installation. If in doubt, contact a qualified marine electrician.

Yes, a circuit breaker is essential to protect the motor and cables from overheating and damage. It must never be disabled or bypassed. The circuit breaker must be used to isolate the windlass when not in use.

The geared motor must be positioned so that it is not directly under the fall zone of the rope or chain. It is also important to ensure that the mounting surfaces of the geared motor and the windlass are parallel.

The recommended tightening torque for the mounting studs is 21 Nm (Newton-metres). M8 nuts should also be tightened to 21 Nm, ideally using a Loctite® threadlocker.

Yes, as a Lewmar product, this gearbox is generally covered by the manufacturer's warranty. For specific details regarding duration and conditions, please refer to Lewmar's official warranty policy.