Lewmar VX2+ Windlass – 12 V 1000 W, 8 mm Chain

The Lewmar VX2+ windlass has a power output of 1000 W.

This Lewmar VX2+ windlass operates at 12 V.

No, the Lewmar VX2+ windlass is not equipped with a warping drum. It is a single gypsy model.

The Lewmar VX2+ windlass gearbox has IP67 protection, meaning it is dust-tight and protected against temporary immersion.

A Lewmar VX2+ windlass is designed and supplied solely for anchor control in marine applications, i.e., for deploying and retrieving the anchor. It must not be used for any other purpose.

No, a windlass must never be used as a mooring cleat. The anchor rode must absolutely be secured to a mooring cleat, a chain stopper, or another designated solid anchor point. Using the windlass to secure the anchor rode will damage it.

Yes, classification societies and Lewmar require that a vessel at anchor must have its anchor chain or rode held by a chain stopper or equivalent strong anchoring point at all times. Anchors must be independently secured to prevent accidental deployment, especially in storm conditions.

Lewmar recommends a minimum deck thickness of 40 mm (1 1/2") for installing the VX2+ windlass.

For a thicker deck, a longer shaft may be required as it is not standard. It is recommended to contact your Lewmar representative for further information and the appropriate parts.

For a thinner deck, a deck spacer (part number 65100038) is available to compensate for the missing thickness and ensure correct installation.

There must be a minimum vertical drop of at least 300 mm (12”) for the chain or line during retrieval. Failure to comply will cause jams.

A suitable marine sealant must be applied to the edges of freshly cut holes to prevent water absorption through the deck. It is important NOT to use permanent adhesive/sealant such as 5200.

The motor/gearbox must be positioned so that it is not located under the fall zone of the rope/chain. It must be gently slid onto the drive shaft until it touches the deck, ensuring that the mounting surfaces of the motor/gearbox and the windlass are parallel.

The recommended torque for the M8 nuts on the VX2+ windlass is 21 Nm. It is advised to use Loctite® thread locker and, if a silicone sealant is used, to let it cure before the final tightening of the mounting nuts.

This Lewmar VX2+ windlass is specifically designed for an 8 mm chain.

The 8 mm gypsy of the VX2+ windlass is compatible with the following chains:

8 mm ISO 45658 mm DIN7665/16” G40

The VX2+ windlass is compatible with ropes from 12 to 16 mm in diameter (1/2" to 5/8").

Use high-quality anchor windlass ropes, preferably nylon with medium strands. 3-strand and 8-braid braided ropes are compatible. Ropes from different manufacturers may vary in elasticity and diameter consistency, sometimes requiring adjustments to find the optimal size.

Lewmar recommends using only genuine Lewmar parts and accessories to ensure optimal performance and avoid voiding your warranty.

For installation of the Lewmar VX2+ windlass, a minimum deck thickness of 40 mm (1 1/2") is recommended.

Deck thickness is a critical component as it must support the windlass and be strong enough to handle high torque loads during anchor retrieval.

Regarding possible adjustments:

For a thicker deck, a longer shaft may be required (non-standard). For a thinner deck, a deck spacer (part number 65100038) is available.