Blue smart IP67 24/12 (1+si) 230V CEE 7/7 battery charger

The Victron Energy Blue Smart IP67 24/12 charger delivers a main output voltage of 24 volts with a maximum charging current of 12 amperes.

Yes, this charger has an IP67 protection rating. This means it is fully protected against dust and can be submerged in water up to one meter deep for a limited time. It is therefore perfectly suited to marine and humid environments.

The Blue Smart IP67 charger is compatible with different battery types, including lead-acid batteries (with normal and high charge modes) and lithium-ion batteries.

This charger operates on an input voltage range of 180 to 265 VAC and a frequency of 45 to 65 Hz. It is equipped with a CEE 7/7 plug.

The charger is equipped with Bluetooth Smart connectivity, allowing you to configure and monitor it remotely via a compatible mobile app.

Yes, the charger is equipped with an overheat protection. If the internal temperature of the charger reaches 50 °C, the output current will be automatically reduced to prevent any damage and ensure the device's safety.

Yes, the Blue Smart IP67 battery charger can also be used as a power supply.

The dimensions of this charger are 99 mm (height) x 219 mm (length) x 65 mm (depth). Its weight is 2.4 kg.

The "(1+Si)" marking in the reference indicates the presence of a start-stop interruption option (Si). This output is short-circuit proof, has a current limit of 0.5 A, and its output voltage is at most one volt lower than that of the main output. It is specifically available on the 12/25 and 24/12 models.

This charger uses a 5-stage adaptive charging algorithm. The algorithm optimizes recharging for different battery types, ensuring efficient and safe charging.

The charger can operate within a temperature range from -20 to +60 °C. It maintains its maximum nominal power up to 40 °C, with a 3 % reduction per °C above 40 °C.

Yes, the charger is equipped with output short-circuit protection. If a short circuit is detected, the charger stops immediately to protect the device and the battery.

No, it is important never to charge a lithium-ion battery if its temperature is below 0 °C to avoid damaging the battery.

The default Bluetooth PIN for the initial connection is 000000. It is recommended to change it after the first pairing for security reasons.

The charger's power consumption in standby mode is very low, at only 0.5 W.

Charge voltages for 24V systems vary depending on battery type:

Absorption: 28.8 V (standard), 29.4 V (high), 28.4 V (Li-ion)Float: 27.6 V (standard/high), 27.0 V (Li-ion)Storage: 26.4 V (standard/high), 27.0 V (Li-ion)

Yes, for lead-acid batteries only, the charger includes a temperature compensation of -32 mV/°C for a 24V system, ensuring accurate and optimized charging based on thermal conditions.

To disable Bluetooth, you must first establish the initial Bluetooth connection with the default PIN code (000000) or the currently configured PIN code, then follow the deactivation steps via the app. To reactivate it, simply unplug and replug the AC power.

The charger is equipped with two LED indicators:

The green indicator (Power) shows that the charger is powered on and running. The yellow indicator (Status) shows the current charging phase: fast blinking for Bulk, slow blinking for Absorption/Recovery/Refresh, solid for Float/Power supply mode, and off for Standby.

The Blue Smart IP67 24/12 charger has a high efficiency of 96%. This means it produces three to four times less heat than less efficient chargers, which contributes to better performance and durability.