Supersub 1100 - 24 V automatic bilge pump

In automatic mode, the Whale Supersub 1100 SS1224 bilge pump operates with a 5-second start delay. This means that once activated by the water level, the pump will begin running after this short delay.

Yes, the Whale Supersub Smart 1100 automatic bilge pump, part number SS1224, comes with an integrated non-return valve (N.R.V.).

The Supersub Smart range, which includes the SS1224 pump, is known for its low-profile, narrow-design electric bilge pumps. These pumps are specifically designed for automatic operation.

The Whale Supersub 1100 bilge pump, part number SS1224, requires a 24 V DC power supply to operate correctly.

Yes, a mounting bracket is provided specifically with the Supersub range automatic pumps, including the SS1224 model.

The '1100' in 'Supersub 1100' refers to the pump's flow rate capacity, expressed in gallons per hour (GPH). This indicates the volume of water the pump can discharge in one hour.

This Whale Supersub 1100 automatic bilge pump (model SS1224) requires a 24 V DC power supply.

The Whale Supersub 1100 pump (model SS1224) is an automatic pump. It is part of the Supersub Smart range, meaning it detects the presence of water and activates accordingly.

In automatic mode, the Supersub Smart 1100 pump detects the presence of water and starts running. It then shuts off automatically when the water level has dropped sufficiently. The switching system uses solid-state components, meaning there are no moving parts for detection.

Yes, the pump operates with a 5-second delay before activating in automatic mode. This prevents unintended activations caused by waves or boat movement.

Yes, the Supersub Smart 1100 (SS1224) model is supplied with an integrated non-return valve (N.R.V.).

This pump is designed for use in the bilges of recreational craft. If used as the sole or primary bilge pump, it is suitable for boats up to 24 meters (78.8 feet) in length.

The pumped water must be discharged through a through-hull fitting correctly installed above the boat's waterline. The pump is not designed for systems that discharge water through a through-hull fitting or hull valve located below the waterline. Additionally, all piping must include a properly installed check valve or anti-siphon loop.

To test automatic operation, set the 3-position switch to "Automatic". Place your fingers on the sensor area to check activation (wait 5 seconds), then remove your fingers and wait for the pump to stop (approximately 25 seconds). It is recommended to regularly inspect the pump to ensure no clogging occurs.

The mounting surface to which the pump is attached must have a minimum thickness of 19 mm (3/4 inch) to ensure secure fastening.

The pump must be mounted on a bulkhead or an additional board. It is important not to screw it directly onto the hull.

Yes, a mounting bracket is included with the Supersub automatic pumps range, including this SS1224 model, to optimize installation.

For the Supersub 1100 pump (models SS1012, SS1024, SS1212 and SS1224), a 1-inch through-hull fitting (reference SF5204) is recommended.

No, the Supersub product line is considered non-repairable. If the pump fails, a complete replacement of the pump is required.

Due to the extreme conditions encountered in boat bilges (temperature fluctuations and varied chemical environments), it is recommended to replace your submersible bilge pump at least every 3 years.