Rafskynjari fyrir dýptarmæla

The unit must be mounted vertically, with cables exiting from the bottom. It is important to note that the mounting template must be reversed relative to the transducer itself.

You will need to drill three 2.5 mm holes to secure the T912. These holes are marked 'B' on the provided mounting template.

The T912 is mounted using the self-tapping screws supplied with the unit.

Yes, it is very important not to overtighten the screws when mounting the T912. Excessive tightening could damage the device’s housing and compromise its integrity.

Transducer cables must be connected following the color code indicated on the unit. It is also essential to sleeve the ground braids to prevent short circuits.

For a Triducer, the ground braid must be connected to the depth connector, not the speed connector. This is critical to avoid short circuits and ensure proper operation.

If your speed sensor does not include a temperature sensor, you must connect the brown and white wires of the speed connector. This ensures proper data interpretation by the transducer.

Yes, it is recommended to apply silicone grease to the terminal contacts. This optimizes conductivity and provides additional protection to the electrical connections.

It is recommended to secure and support cables near the transducer. This helps reduce strain on connections and maintains a clean and secure installation.

Yes, the T912 can be used with existing or older transducers. However, it is recommended to carefully check the connections and wiring, especially for speed transducers without a temperature sensor, to ensure proper connection between the brown and white terminals.

The T912 transmits depth, speed, and temperature data collected from connected transducers. This information is then used by Raymarine instrument systems for display and analysis.